Wooden cinder blocks1/17/2024 ![]() ![]() Place the furring strips into position against the wall and slide the sleeve anchors into the holes. Drill the holes through the paint marks on the furring strips. One way to match up the holes on the furring strips with the holes in the cinder blocks is to slide the sleeve anchors into the holes, paint the nuts on the sleeve anchor bolts, then press the furring strips up against the nuts. The bit should be the same size as the concrete sleeve anchors.Ĭlear the holes with a wet-dry vacuum or a wire brush to remove any debris.ĭrill holes through the furring strips for the concrete sleeve anchors. Drill a hole every 12 inches, staggering the holes slightly to help prevent the wood from splitting. Use a hammer drill with a carbide-tipped masonry bit to drill pilot holes into the cinder block wall where you are installing the furring strips. Make several more marks on the wall along the same line, using the level to ensure the marks are in alignment. Make one mark on the wall measuring 24 inches, then place a carpenter's level vertically on the wall along the mark. Mark the cinder block wall every 24 inches with a marker so you know where the furring strips are being installed. Don't lay the part of the board you're cutting over any other objects and wear safety goggles when cutting. Set the depth of the saw blade so the bottom is an eighth-inch beneath the boards, then line up the blade with the cut line and make the cut. Measure and mark the cut line on the boards and place them on a workbench or across sawhorses. (The furring strips will be placed 24 inches apart.) Cut pressure-treated 2-by-4s to match the height of the privacy fence with a circular saw. For more information, visit makeitright.ca.Determine the number of furring strips you need by measuring the length of the wall where you're building the fence in inches and dividing it by 24. Watch Mike in his new series, Home Free, airing Wednesdays at 9 p.m. If any one of those elements doesn’t work or make sense, the entire build is compromised. We have to look at the environment we’re building in, the materials we’re using and the professionals we hire to do the work to get it right. ![]() Also, you won’t know if there are any voids in the concrete, which could affect the structural integrity of the wall.īut the big drawback is that they are fairly new, so it might be difficult to find a professional contractor who knows how to install them right.Ī good home starts with a solid foundation. ![]() The downside to ICFs is that they’re expensive. The forms fit together like Lego, and can be used from the foundation right up to the roofline. The forms are reinforced with steel, and then concrete is poured in the centre. ICFs are forms made from rigid foam insulation with a hollow centre. In general, when building foundations, I prefer concrete over wood, but what I really like are insulated concrete forms, or ICFs. ![]() (Concrete must be poured all at once, and it has to be protected from the weather as it sets.) If it’s not poured properly, or if the concrete isn’t allowed to set (or cure) the way it should, the strength of a poured concrete foundation will be compromised. Article contentĪnd like anything else, it needs to be done right. This advertisement has not loaded yet, but your article continues below. Manage Print Subscription / Tax Receipt. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |